Skip to main content

Introduction

Replacing a CV Joint requires some care and specific tools.

  1. With the vehicle resting on the ground, loosen the axle shaft nut and the wheel bolts; With the vehicle suspended, remove the wheel; Loosen the pivot and tie rod end nuts; Using an extractor, remove the pivot and tie rod end; Using a lever, force the tray down to disengage the pivot;
    • With the vehicle resting on the ground, loosen the axle shaft nut and the wheel bolts; With the vehicle suspended, remove the wheel;

    • Loosen the pivot and tie rod end nuts; Using an extractor, remove the pivot and tie rod end;

    • Using a lever, force the tray down to disengage the pivot;

    • Pull the axle sleeve to release the Fixed Joint, if necessary, use a polyurethane hammer;

    • Remove the Gearbox Tulip;

  2. Remove the hood clamps and remove the tulip tripod;
    • Remove the hood clamps and remove the tulip tripod;

    • Using ring pliers, remove the lock and tripod;

    • Clean the half shaft to avoid grease contamination.

  3. Manually assemble the Hood; Position the Tripod spline on the Half-shaft spline;
    • Manually assemble the Hood;

    • Position the Tripod spline on the Half-shaft spline;

    • Place the lock;

    • Fit the Tripod into the Tulip;

    • Place the hood clamps.

  4. Fit the Tulip into the Gearbox; Place the end of the Fixed Joint on the Hub. Fit the axle sleeve onto the Pivot. Install the steering terminal; Tighten the pivot and steering terminal nuts. Insert the cotter pins;
    • Fit the Tulip into the Gearbox;

    • Place the end of the Fixed Joint on the Hub. Fit the axle sleeve onto the Pivot. Install the steering terminal;

    • Tighten the pivot and steering terminal nuts. Insert the cotter pins;

    • Install the new axle shaft nut, do not reuse the old nut. Position the Wheel and wheel bolts.

    • With the vehicle resting on the ground, tighten the wheel nuts and apply 330 Nm to the semi-axle nut;

    • To prevent accidental loosening, crimp the axle nut collar into the recess in the joint.

  5. Under no circumstances should you attempt any repair or maintenance for which you are not trained or if you do not have the tools and equipment to perform the repair.
    • Under no circumstances should you attempt any repair or maintenance for which you are not trained or if you do not have the tools and equipment to perform the repair.

    • Always wear proper safety glasses when performing any type of maintenance. Failure to wear safety glasses may result in injury and/or partial or complete loss of vision.

    • Always be careful when working with products that have sharp edges.

    • An important part of your workshop’s work and operation is the correct disposal of products that will be replaced. Do your part and together we can contribute to a sustainable future.

    • Find out more at http://www.spicer.com.br/danatureza

Conclusion

Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.

Spicer

Member since: 09/02/2016

583 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 140

spicer.com.br | sac@spicer.com.br | 0800-727-7012