Skip to main content

Introduction

Replacing a half shaft requires some care and specific tools.

  1. 
With the vehicle resting on the ground, loosen the axle shaft nut and wheel bolts; With the vehicle suspended, remove the wheel;

Loosen the nuts on the lower pivot and tie rod end; Using an extractor, remove the pivot and end;

Using a lever, force the tray down to disengage the pivot;
    • With the vehicle resting on the ground, loosen the axle shaft nut and wheel bolts; With the vehicle suspended, remove the wheel;

    • Loosen the nuts on the lower pivot and tie rod end; Using an extractor, remove the pivot and end;

    • Using a lever, force the tray down to disengage the pivot;

    • Pull the axle sleeve to release the Fixed Joint, if necessary, use a polyurethane hammer;

    • Using a lever, pull the Tulip to disengage it from the differential half shaft.

  2. 
Fit the Tulip onto the differential half shaft, inspect the bearing and the seal;

Place the end of the Fixed Joint into the Hub. Fit the axle sleeve to the pivot. Install the steering terminal;

Tighten the Pivot and Tie Rod End nuts.
    • Fit the Tulip onto the differential half shaft, inspect the bearing and the seal;

    • Place the end of the Fixed Joint into the Hub. Fit the axle sleeve to the pivot. Install the steering terminal;

    • Tighten the Pivot and Tie Rod End nuts.

    • Place the new half-shaft nut, do not reuse the old nut. Position the Wheel and Wheel Bolts.

    • With the vehicle resting on the ground, tighten the wheel nuts. Apply 145 Nm to the half-shaft nut.

  3. 
Under no circumstances should you attempt any repair or maintenance for which you have not been trained or if you do not have the tools and equipment to repair it.
    • Under no circumstances should you attempt any repair or maintenance for which you have not been trained or if you do not have the tools and equipment to repair it.

    • Always wear the proper safety glasses when performing any type of maintenance. Failure to wear safety glasses could result in injury and/or partial or complete loss of vision.

    • Always be careful when working with products that have sharp edges.

    • An important part of the work and operation of your workshop is the correct disposal of the products that will be replaced. Do your part and together we contribute to a sustainable future.

    • Find out more at http://www.spicer.com.br/danatureza

Conclusion

Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.

Spicer

Member since: 09/02/2016

583 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 4

All Time: 76

spicer.com.br | sac@spicer.com.br | 0800-727-7012