Introduction
Replacing a half shaft requires some care and specific tools.
-
-
Loosen the 6 fixing screws of the axle end sliding joint;
-
Loosen the 6 screws securing the tulip's Slip Joint and remove the axle shaft from the vehicle.
-
-
-
Fit the Slip Joint into the gearshift tulip; fit the hood flange and the fixing plates. Put the screws in;
-
Fit the other Slip Joint onto the axle shaft; fit the hood flange and the fixing plates. Put the screws in;
-
Apply 40 Nm of torque to the 6 Sliding Joint fixing screws;
-
-
-
Under no circumstances should you attempt any repair or maintenance for which you have not been trained or if you do not have the tools and equipment to repair it.
-
Always wear the proper safety glasses when performing any type of maintenance. Failure to wear safety glasses could result in injury and/or partial or complete loss of vision.
-
Always be careful when working with products that have sharp edges.
-
-
-
An important part of the work and operation of your workshop is the correct disposal of the products that will be replaced. Do your part and together we contribute to a sustainable future.
-
Find out more at http://www.spicer.com.br/danatureza
-
Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.
Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.
