Introduction
Replacing a CV Joint Repair Kit requires some care and specific tools.
Tools
Parts
No parts specified.
-
-
Remove the hood and clamps;
-
-
-
Keep the axle level;
-
Place the hood on the shaft with the opening facing upwards, preferably at 45°;
-
Place the screws, washers and nuts, and close the hood;
-
Set the clamps aside.
-
-
-
Under no circumstances should you attempt any repair or maintenance for which you have not been trained or if you do not have the tools and equipment to repair it.
-
Always wear the proper safety glasses when performing any type of maintenance. Failure to wear safety glasses could result in injury and/or partial or complete loss of vision.
-
Always be careful when working with products that have sharp edges.
-
-
-
An important part of the work and operation of your workshop is the correct disposal of the products that will be replaced. Do your part and together we contribute to a sustainable future.
-
Find out more at http://www.spicer.com.br/danatureza
-
Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.
Avoid damage and premature wear, after installing the Half-shaft, check the vehicle's geometry.
